Details For JET A Groups

Details For JET A Groups

APPLICATION

Selfpriming water pumps for deep suctions up to mt. 35 to be used in case of important water level gaps. Suitable to drain water from wells and in domestic fittings by small and medium sized tanks. Before installing the pump verify that all pipes (iron, plastic or rubber) are clean inside so to avoid any obstruction to the ejector nozzle. At the foot of the ejector must be installed a foot valve or a check valve. Installed the pump, fill completely both pipes and pump body with clean water. To preserve an efficient priming it is necessary a certain pression in the circuit, therefore it is recommended to install a membrane tank at the delivery of the pump.

  • JET A 100
  • JETt A 100
  • JET A 150
  • JET A 200

OPERATING CONDITIONS

- Liquid temperature up to 35°C (for home use according to EN 60335-2-41)

   Temperature max. liquid: 35°C (for other uses)

- Ambient temperature up to 40°C

- Total suction lift up to 35 mt.

- Continuous duty

MOTOR

- Single-phase 230V-50Hz

- Three-phase 230/400V-50Hz

- Two-Pole induction motor (n = 2850 min-1)

- Insulation Class F

- Protection IP 44

MATERIALS

- Pump body Cast Iron

- Motor support Cast Iron

- Impellers Noryl

- Diffuser Noryl

- Ejector (P30) Cast Iron

- Shaft with rotor Stainless Steel AISI 304

- Mechanical seal Ceramic/Graphite/NBR

Water Pumps Made In ITALY

Full Name
Phone Number
Current E-mail